What the error means
NW-102307-3 is a network error on PS5. Sony's error page describes it as "A communication error has occurred while connecting to PlayStation." The console tried to reach PlayStation's servers and the exchange did not complete. That can happen for two very different reasons: PlayStation's own services are down or under maintenance, or something between your console and the internet, such as weak Wi-Fi or the router, is interrupting the connection.
Sony's steps handle the first case before the second. There is no point changing router settings during a PlayStation Network outage, and a status check takes seconds. Around big releases such as GTA 6, checking the status page first can save a lot of unnecessary troubleshooting.
Common causes
- A PlayStation server failure or scheduled maintenance.
- A weak or obstructed Wi-Fi connection between the console and the router.
- A router or modem that needs restarting, or router firmware that needs updating.
- Port filtering on the router blocking the connection.
How to fix it
1. Check the PlayStation status page
Open the PlayStation status page on a phone or computer and look for a server failure or maintenance notice. If one is listed, wait until it is resolved and try again later. None of the steps below can fix a service outage.
2. Restart the console and set up the connection again
Restart the PS5 and, if possible, connect it to the router with a LAN cable. Then configure the network settings again. If you have to use Wi-Fi, move the console as close as possible to the router and remove anything that could block or interfere with the signal.
3. Restart the router and modem
Turn off the router and modem, wait at least five minutes, then turn them back on. As a general step from Sony's other connection guides, run the connection test on the PS5 under Settings, Network, Test Internet Connection after they reconnect. Menu names can differ slightly between system software versions.
4. Update the router firmware and check port filtering
Sony says to contact your internet service provider or network administrator to update the router firmware. If possible, ask the provider how to turn off the port filtering function on your router. Do this only with their guidance, because router settings affect every device at home.
5. Set a static IP address manually
As a later step, Sony suggests setting up a static IP address manually. Go to Settings, Network, Settings, Set Up Internet Connection. Use an address your router allows; if you are not sure which addresses are free, ask whoever manages the router first.
6. Try again later
If you still see the error, Sony's last advice is simply to try again later.
If nothing works
Note when the error happens (signing in, opening the store, joining an online game) and whether other devices on the same network work. For connection problems with a specific game at launch, the GTA 6 launch and crash guide covers status checks and connection messages in order. Contact PlayStation Support if the error continues on a working network with no reported outage.
What we checked
Sony's PS5 error code page for NW-102307-3 on playstation.com was read on 2026-11-19. It describes a communication error while connecting to PlayStation and lists the steps used above, in the same order: status page, restart with a wired connection and reconfigured network, router and modem restart, router firmware and port filtering through the internet provider, a manual static IP address, and trying again later. The error was not reproduced for this page.
Last checked: 2026-11-19.